NULL-pointer / out-of-bounds write in Zephyr MCTP I2C+GPIO target binding driven by an unauthenticated I2C controller

The MCTP-over-I2C+GPIO target binding in Zephyr (subsys/pmci/mctp/mctp_i2c_gpio_target.c) processes pseudo-register writes from an I2C bus master byte-by-byte in mctp_i2c_gpio_target_write_received() without validating the order or the receive buffer. In the affected versions the MCTP_I2C_GPIO_RX_MSG_ADDR (data) handler dereferences and writes through b->rx_pkt without checking that the receive buffer was allocated: a controller that selects the data register and writes a byte without first sending the length register (which is what allocates the buffer) causes a write of an attacker-chosen byte through a NULL/unallocated mctp_pktbuf pointer (i.e. into a small attacker-advanceable offset above address 0), producing memory corruption or a hard fault. The same handler also performs a write-then-check bounds test, allowing a one-byte heap overflow at data[255] when more than 255 data bytes are sent. Because the I2C target callback is invoked with raw bytes supplied by whatever device is the bus master and the binding performs no authentication, a malicious or malfunctioning controller on the bus can trigger these without any prior protocol state, leading to memory corruption and/or denial of service on the target device. The vulnerable code was introduced when the I2C+GPIO target binding was added and shipped in Zephyr v4.3.0 and v4.4.0. The fix defers allocation to the first data byte with a NULL check, treats a missing length as a zero-sized packet rejected by libmctp, and mov