Zephyr RTIO syscall verifier validates output parameters for read instead of write access

The user-mode syscall verifier z_vrfy_rtio_cqe_get_mempool_buffer() in subsys/rtio/rtio_syscalls.c validated its two output parameters, buff and buff_len, with K_SYSCALL_MEMORY_READ() rather than K_SYSCALL_MEMORY_WRITE(). Both are pure out-parameters: z_impl_rtio_cqe_get_mempool_buffer() stores the mempool buffer address and its length through them. The distinction is enforced by every architecture validator — arch_buffer_validate() on RISC-V PMP explicitly accepts the global __rom_region/__rodata_region for reads only, and the ARM MPU validators accept P_RO_U_RO and P_RW_U_RO regions for reads only — so a read-validated pointer is not necessarily writable by the calling thread. An unprivileged user-mode thread that has been granted access to an RTIO context (rtio_access_grant()) can invoke the rtio_cqe_get_mempool_buffer() syscall with buff/buff_len pointing at memory it may read but not write, and with a completion-queue entry whose flags field it fully controls (only RTIO_CQE_FLAG_MEMPOOL_BUFFER in flags[7:0] is required; flags[19:8] and flags[31:20] supply the block index and count). The kernel then performs a pointer-sized and a 4-byte store through those addresses while running in supervisor mode. Reaching the store requires CONFIG_USERSPACE together with CONFIG_RTIO_SYS_MEM_BLOCKS, the configuration behind RTIO_DEFINE_WITH_MEMPOOL; without the latter the implementation returns -ENOTSUP and writes nothing. Two outcomes follow. If the target lies in a memory-domain parti